QoS ATM Traffic Descriptor Profiles
Quality of Service Guide 711
===============================================================================
Maximum Supported Profiles : 1000
Currently Configured Profiles : 3
-------------------------------------------------------------------------------
TDP-id Description
Service Category SCR PIR MIR MBS
-------------------------------------------------------------------------------
1 Default Traffic Descriptor
UBR - 0 0 -
-------------------------------------------------------------------------------
2 Default Traffic Descriptor
NRT_VBR 4000 5000 - 32
-------------------------------------------------------------------------------
10 Default Traffic Descriptor
NRT_VBR 4000 5000 - 32
===============================================================================
A:ALA-48>config>qos>atm-td-profile#
A:ALA-48>config>qos>atm-td-profile# show qos atm-td-profile 10 detail
===============================================================================
Traffic Descriptor Profile (10)
===============================================================================
-------------------------------------------------------------------------------
TDP-id Description
Service Category SCR PIR MIR MBS
-------------------------------------------------------------------------------
10 Default Traffic Descriptor
NRT_VBR 4000 5000 - 32
-------------------------------------------------------------------------------
TDP details
-------------------------------------------------------------------------------
Shaping : disabled
-------------------------------------------------------------------------------
Entities using TDP-10
-------------------------------------------------------------------------------
===============================================================================
A:ALA-48>config>qos>atm-td-profile#
sap-using
Syntax sap-using [ingress | egress] atm-td-profile td-profile-id
Context show>service
Description Displays atm-td-profile SAP information.
If no optional parameters are specified, the command displays a summary of all defined SAPs.
The optional parameters restrict output to only SAPs matching the specified properties.
Parameters ingress — Specifies matching an ingress policy.
egress — Specifies matching an egress policy.
To Next Page
Loading...
