ATM QoS Policy Command Reference
710 Quality of Service Guide
atm-td-profile
Syntax atm-td-profile [traffic-desc-profile-id] [detail]
Context show>qos
Description This command displays ATM traffic descriptor profile information.
Parameters traffic-desc-profile-id — Displays the ATM traffic descriptor profile.
Values 1 to 1000
detail — Displays detailed policy information including policy associations.
Output ATM TD Profile Output — Table 56 describes ATM traffic descriptor profile show command
output.
Sample
A:ALA-48>config>qos>atm-td-profile# show qos atm-td-profile
===============================================================================
Traffic Descriptor Profiles
Table 56: ATM Traffic Descriptor Profile Command Output Fields
Label Description
Maximum Supported
Profiles
Displays the maximum number of ATM traffic descriptor profiles that can
be configured on this system.
Currently Configured
Profiles
Displays the number of currently configured ATM traffic descriptor
profiles on this system.
TDP-Id The ID that uniquely identifies the traffic descriptor policy.
Description A text string that helps identify the policy’s context in the configuration
file.
Service Category Displays the ATM service category.
SCR Displays the sustained cell rate in Kbps.
PIR Displays the peak cell rate in Kbps.
MIR Displays the Minimum Desired Cell Rate in Kbps.
MBS Displays the maximum burst size in cells.
Shaping Displays whether shaping is enabled or disabled for the traffic descriptor
profile.
Entities using TDP-ID Displays the number of entities using the ATM traffic descriptor.
- Indicates that the parameter is not applicable for the configured service
category.
To Next Page
Loading...
