EasyManua.ls Logo

Alliance Laundry Systems DCG020ND - Page 162

Alliance Laundry Systems DCG020ND
186 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Display Description Cause/Corrective Action
E StHt
Slow To Heat Error (Heat Models
Only)
Non-Fatal Error that will appear during the running cycle without
affecting the cycle.
The control sounds an alarm tone for 15 seconds.
To clear the error, press any keypad.
E SudS
Suds Lock Error In the spin steps, if the control determines that there are suds in the
machine after running all programmed Suds Routines, it will dis-
play a Suds Lock Error at the end of the cycle after the door is
opened.
To clear the error, wait 1 minute, open the door, or press any key-
pad.
Eio 29
Mosfet Enable Pin Failure The Input/Output Board senses a problem with the hardware.
The control sounds an alarm tone for 15 seconds.
To clear this error either power down the machine or simultaneous-
ly press the Normal and Warm keypads.
Eio 30
Door Lock Solenoid Disable Pin
Failure
The Input/Output Board senses a problem with the hardware.
The control sounds an alarm tone for 15 seconds.
To clear this error either power down the machine or simultaneous-
ly press the Normal and Warm keypads.
Eio 31
Door Lock Solenoid Pulse Pin Fail-
ure
The Input/Output Board senses a problem with the hardware.
The control sounds an alarm tone for 15 seconds.
To clear this error either power down the machine or simultaneous-
ly press the Normal and Warm keypads.
Eio 32
Door Lock Solenoid Relay Pin Fail-
ure
The Input/Output Board senses a problem with the hardware.
The control sounds an alarm tone for 15 seconds.
To clear this error either power down the machine or simultaneous-
ly press the Normal and Warm keypads.
Eio 33
Mosfet Enable Hardware Failure The Input/Output Board senses a problem with the hardware.
The control sounds an alarm tone for 15 seconds.
To clear this error either power down the machine or simultaneous-
ly press the Normal and Warm keypads.
Eio 34
Door Lock Solenoid Disable Hard-
ware Failure
The Input/Output Board senses a problem with the hardware.
The control sounds an alarm tone for 15 seconds.
To clear this error either power down the machine or simultaneous-
ly press the Normal and Warm keypads.
Table 37  continues...
Error Codes
©
Copyright, Alliance Laundry Systems LLC -
DO NOT COPY or TRANSMIT
162 Part No. F8615401ENR4

Table of Contents