Display Description Cause/Corrective Action
E FbAL
Frame Balance Switch Error During a cycle, the frame balance switch becomes unsatisfied. The
machine enters the Door Unlocking Mode.
The control sounds an alarm tone for 15 seconds.
To clear this error either power down the machine or simultaneous-
ly press the Normal and Warm keypads.
E UbAL
Non-Fatal Unbalance Limit Error If enabled, this error is shown at the end of a cycle. The machine
exceeds the maximum number of balance attempts. If enabled, the
error code is shown in the display after a cycle is complete.
The control sounds an alarm tone for 15 seconds.
To clear the error, wait 1 minute, open the door, or press any key-
pad.
E tE
Max Water Temperature Exceeded
Error (Heat Models Only)
The Input/Output Board flags the Max Water Temperature Exceed-
ed Error and the control sets the fatal error.
The control sounds an alarm tone for 15 seconds.
To clear this error either power down the machine or simultaneous-
ly press the Normal and Warm keypads.
E oP
Open Temperature/Thermistor Sen-
sor Error (Heat Models Only)
This error is shown at the end of a cycle. The input/output board
reports an open thermistor. The heater output is turned off for the
remainder of the current cycle. After the cycle is complete, the er-
ror code is shown in the display.
The control sounds an alarm tone for 15 seconds.
To clear the error, wait 1 minute, open the door, or press any key-
pad.
E LP
Low Level Pressure Switch Error
(Heat Models Only)
This error is only enabled during the Factory Test Cycle . The con-
trol fills to low level and the low level pressure switch then be-
comes dissatisfied. The machine enters Door Unlocking Mode.
The control sounds an alarm tone for 15 seconds.
To clear this error either power down the machine or simultaneous-
ly press the Normal and Warm keypads.
E SH
Shorted Temperature/Thermistor
Sensor Error (Heat Models Only)
This error is shown at the end of a cycle. The input/output board
reports a shorted thermistor. The heater output is turned off for the
remainder of the current cycle. After the cycle is complete, the er-
ror code is shown in the display.
The control sounds an alarm tone for 15 seconds.
To clear the error, wait 1 minute, open the door, or press any key-
pad.
Table 37 continues...
Error Codes
©
Copyright, Alliance Laundry Systems LLC -
DO NOT COPY or TRANSMIT
161 Part No. F8615401ENR4
To Next Page
