Errors Menu Error-
CErr-
Coin Error Parameters Menu
CErr 1
Coin Error - Determines if the
display will show the error.
CErr 2
Coin Error Penalty - If enabled,
the coin error will erase previous
coins entered and reset the vend
price.
CErr 3
Vend Header Present Error - If en-
abled and coin drop header is un-
plugged, the control ignores coin
inputs.
E FL-
Fill Error Menu
E FL 1
Fill Error (On/Off) - If enabled,
the control will set an error after
the programmed Fill Error Time if
the desired fill level is not
reached. If disabled, will allow
filling forever if fill level is never
reached.
E FL 2
Fill Error Time - Time allowed in
minutes to reach target fill level
before setting a fill error.
E nF-
No Water Flow Error Menu
E nF 1
No Water Flow Error (On/Off) - If
enabled, the control will set an er-
ror after the programmed No Wa-
ter Flow Error Time if the water
level has not reached 4 in-
ches[102 mm]. If disabled will al-
low filling forever until the level
is reached.
E nF 2
No Water Flow Error Time - Time
allowed in minutes to reach the
basket fill level ( 4 inches[102
mm]).
E Hd
Too Hot to Drain Error (On/Off) (heat mod-
els) - Error shown at end of cycle if the con-
trol has saved a Too Hot to Drain Error .
Shown after the door is opened or a keypad is
pressed. This error will remain displayed un-
til another keypad has been pressed or one (1)
minute passes.
Table 6 continues...
Errors Menu Error-
E dr-
Drain Error Menu
E dr 1
Drain Error (On/Off) - If enabled,
the control will set an error after
drain error alarm time if empty
water level is not reached, if disa-
bled will allow draining forever if
empty level never reached.
E dr 2
Drain Error Time - Time allowed
in minutes to reach an empty wa-
ter level before setting the drain
error.
E Ld-
Water Leak Detection Error Menu - This
error checks for whether the machine is leak-
ing water by adding 1 minute to the cycle to
check for water leaks.
E Ld 1
Water Leak Detection Day of
Week - If enabled, allows the
owner to pick which days to
check for water leaks.
Refer to Table 9 for the value
definitions.
E Ld 2
Water Leak Detection Number of
Cycles - Sets how many cycles
must run before water leaks are
checked again.
E Ld 3
Water Leak Detection Display Se-
quence (On/Off) - The display
will show a moving dash "-"
across the 7-segment display at an
increasing rate/speed while the
water leak detection is being per-
formed.
E Sd-
Slow Drain Detection Error Menu
E Sd 1
Slow Drain Detection (On/Off) -
Enables/disables the error.
E Sd 2
Slow Drain Detection Adjust -
Allows the owner to add time in
seconds to the machine's default
draining time used to detect for
slow draining conditions. Helps
allow for locations with poor
draining conditions.
Table 6 continues...
Programming Control
©
Copyright, Alliance Laundry Systems LLC -
DO NOT COPY or TRANSMIT
57 Part No. F8615401ENR4
To Next Page
Loading...
