Alliance Laundry Systems DCG020ND - Page 97

Programming the Drain Step Type
The Drain Step Type allows the owner to program the drain steps
of a cycle. After selecting the desired Cycle Step number and
pressing START (enter), XXdrAi will appear in the display.
Press the Delicates Bulky (∧) or the Cold (∨) keypad to scroll
through the options and START (enter) to select a value.
NOTE: To go back to the current programmable option
without changing the value of the active digit, press the
Warm (<) keypad.
Step
Type
Display
A Display B Values Description
XXdrAi Drain Step Type (XX is step number, step type is
flashing)
En diS XXdr01 EnAbLe/diSAbL/dNod 1/
dNod 2
Step Enable/Disable
Choosing dNod 1 and dNod 2 will enable the step
if the cycle modifier is chosen and set to be enabled
in Cycle Modifier Programming Menu CNP-.
StAtUS XXdr02 PrEWSH/WASH/rinSE1/
rinSE2/rinSE3/rinSE4/
SPin
Status LED: The corresponding LED on the control
will be lit during this step.
drAin1 on/oFF
Drain #1
drAin2 on/oFF
Drain #2
rotAtE XXdr06
3-255 Motor On Time (seconds)
PAUSE XXdr07
3-255 Motor Off Time (seconds)
SPEEd XXdr08 no rot/LoW Ag/rEg Ag/
10-50 RPM (X.XX-X.XX G
Force)
Rotation Speed: no rotation, low agitate speed, regu-
lar agitate speed or custom speed in RPM/G Force
• 0.03-0.75 for 20 pound
• 0.04-0.86 for 30 pound
• 0.04-0.94 for 40 pound
• 0.05-1.07 for 60 pound
• 0.06-1.27 for 80 pound
• 0.06-1.27 for 100 pound
rEvErS XXdr09 rEv on/no rEv
Reversing
dELAy XXdr10 on/oFF
Delay rotation until empty.
oUtP 1 XXdr11 on/oFF
External Output #1
oUtP 2 XXdr12 on/oFF
External Output #2
oUtP 3 XXdr13 on/oFF
External Output #3
oUtP 4 XXdr14 on/oFF
External Output #4
Table 22
Programming Control
©
Copyright, Alliance Laundry Systems LLC -
DO NOT COPY or TRANSMIT
97 Part No. F8615401ENR4