ALTAI A2N - Reset Back to Factory Default Via Reset Button

Altai Technologies Ltd. All rights reserved
Altai A2n WiFi Access Point/Bridge Web-Admin Configuration Manual
TPS13-001_rev1.0
2. Keep Network Address Settings: Select this if user doesn’t wish to reset the IP
address configuration to factory default.
3. Once restore to factory default configuration, user can login to the A2n with the
following information:
A2n default IP address：192.168.1.222
Username：admin
Password：admin
6.6.2. Reset back to factory default via reset button
Hardware reset button have 2 functions:
 Soft-reboot [equivalent to UI: Reboot).
o Press & Hold the reset button until you see Power LED blink once
o Then release it immediately
 Reset to factory default [equivalent to UI: Reset factory (NOT retain
network address)]
o Press & Hold the reset button until you see Power LED blink once
o Continue pressing the button until you see Power LED blink twice
consecutively
o Then release it immediately
Factory Default Setting
Current A2n factory default settings are:
Admin Username: admin
Admin Password: admin
Radio0 setting:
 Radio Enable: Enabled
 Operation Mode: AP
 SSID: Superwifi Network <0..15>
 Channel: 1
 Wireless mode: auto, default to 11NG
 ShortGI: Disabled
 AMPDU: Enabled
 Sector: All enabled
 Power: 25dBm
Radio1 setting:
 Radio Enable: Disabled
Network:
 Switch mode with all interface bridged on a virtual interface called br-lan: