Access Traffic Right：Access traffic right controls associated stations the ability to
permit or deny AP management.
Max Clients：Maximum value is 256
Back to Overview：Go back to previous page
Procedures:
1. Select Configuration -> Wireless -> Radio1 (5G) -> WLAN to edit “More…” WLAN,
and then select WLAN General.
2. Enable WLAN select to enable this WLAN
3. VLAN Pass Through allow or don’t allow VLAN pass through
4. VLAN TagId Set VLAN ID
5. SSID set SSID
6. Enable Intra-WLAN Forwarding: Allow or block
7. Max Clients Maximum is 256
8. Click Submit
9. Click Save&Apply to apply
5.3.2.2.2. WLAN X (0-15) Security
A2n 5GHz supports Open, Shared Key, WPA, WPA-PSK, WPA2, WPA2-PSK, WAPI, WAPI-
PSK authentication mode, and Disabled, WEP, AES, TKIP, SMS4 cipher mode.
Select Configuration -> Wireless -> Radio1 (5G) -> WLAN to select “More…” WLAN,
and then select WLAN Security to access to security configuration page.
Figure 5-52 5G AP Mode WLAN Security setting
Note: Please refer to 6.4.1.5 WLAN security setting
To Next Page
Loading...
