1. Introduction
This manual is to summarize how to perform basic configuration for the Altai A2n
Access Point/Bridge through web-admin interface.
2. A2n Model and Firmware Version
This manual is applicable for the following models, hardware and firmware versions:
Product name : A2n Access Point/Bridge
Table 2-1 A2n model
3. Getting Started
3.1. Setup Local Area Connection on Your PC
A2n Access Point can be connected to your PC in wired mode or in wireless mode. In
the following, wired mode will be introduced. This is because the configurations are
similar in wireless mode, except SSID has to be configured in both A2n Access
Point/Bridge and PC.
A2n Access Point/Bridge can be connected to your PC directly or by a switch or a
hub.
Start Network Configuration on your PC.
For Windows XP user,
1. Click the “start” menu and choose “Control Panel”.
2. Click “Network Connections”.
To Next Page
Loading...
