Enable WLAN：Enable or disable this WLAN.
VLAN Pass Through：VLAN pass through for this WLAN.
Hide SSID：Hide this SSID or not.
SSID：Set SSID name.
Enable Intra-WLAN User Isolation：Allow or block intra-WLAN user communication. By
default, it is enable.
Allow DHCP Snooping Trusted Port：DHCP snooping prevents illegal DHCP servers
from offering IP address on untrusted wireless port.
Access Traffic Right：Access traffic right controls associated stations the ability to
permit or deny AP management.
Max Clients：Maximum value is 256.
Minimum signal for association: Set the minimum signal value (SNR) for client can
associate to this WLAN. The range is 0~100dB, and 0 means disable.
Disconnect Signal Threshold：Set the signal threshold value (SNR) for client to
disconnect to this WLAN.
Disconnect Packet Threshold：Set the packet threshold value (SNR) for client to
disconnect to this WLAN.
Back to WLAN List：Go back to previous page
Procedures:
1. Select Configuration -> Wireless -> Radio0 (2.4G) -> WLAN to click “More…”
behind the WLAN, and then select WLAN General.
2. Enable WLAN select to enable this WLAN
3. VLAN Pass Through allow or don’t allow VLAN pass through
4. VLAN TagId Set VLAN ID
5. SSID set SSID
6. Allow Intra-WLAN User Isolation: Allow or block intra-WLAN User communication.
7. Max Clients Maximum is 64
8. Click Submit
9. Click Save&Apply to apply
5.3.1.2.2. WLAN X (0-15) Security
A2n 2.4GHz supports Open, Shared Key, WPA, WPA-PSK, WPA2, WPA2-PSK, WAPI,
WAPI-PSK authentication mode, and Disabled, WEP, AES, TKIP, SMS4 cipher mode.
Select Configuration -> Wireless -> Radio0 (2.4G) -> WLAN to edit “More…” behind
the WLAN, and then select WLAN Security to access to security configuration page.
To Next Page
Loading...
