Preferred AP0 Mac: The station shall be able to input the 3 preferred AP (WDS) MAC
Addresses, in the order of priority.
Preferred AP1 Mac: The station shall be able to input the 3 preferred AP (WDS) MAC
Addresses, in the order of priority.
Preferred AP2 Mac: The station shall be able to input the 3 preferred AP (WDS) MAC
Addresses, in the order of priority.
Enable Roaming: Enabled or disabled roaming.
Minimum signal for association: By default, it is 0dB, and if an associated station UL
SNR drops below X by Y dB, for a consecutive number of Z packets, this station shall
be disassociated by the AP.
Disconnect Signal Threshold: By default, it is 10dB.
Disconnect Packet Threshold: By default, it is 10 packets.
5.3.2.3.2. Station Security
A2n 5GHz supports Open, Shared Key, WPA, WPA-PSK, WPA2, WPA2-PSK, WAPI, WAPI-
PSK authentication mode, and Disabled, WEP, AES, TKIP, SMS4 cipher mode.
Select Configuration -> Wireless -> Radio1 (5G)-> Station to edit “More…” then select
WLAN Security to access to security configuration page.
Figure 5-58 5G Station security setting
Note: Please refer to 6.3.1.2.2. Section about the 2.4G AP Mode WLAN security setting
5.3.2.4. 5G General setting — Repeater Mode
Select Configuration -> Wireless -> Radio1 (5G), and then select “Repeater” for Radio
Mode.
To Next Page
Loading...
