Figure 7-1 2.4G Channel Scan
Details of 2.4G Channel Scan：
Start Scan ：Press Start Scan to start 2.4G channel scan。
Duration：The switching time of the channel scanning interval, setting range is 100-
1000ms，default is 100ms.
Scan Status：A2n Base station channel scan status, “Ready” means it can start scan.
“Success” means scan finished.
Procedures:
1. In the main menu, select Tools -> Channel Scan -> radio1
2. Press Start Scan
3. Wait until the scan status change to “Success”. The scanning will take
approximately 20 seconds
Result will be divided into 6 parts: Channel Usage Info, Overall BSS Info, Sector 0 BSS
Info, Sector 1 BSS Info, Sector 2 BSS Info and Sector 3 BSS Info.
1) Channel Usage Info
To Next Page
Loading...
