Internet Connection Type： Static IP or DHCP client
IPv4 Address： If A2n uses static IP, please give it a fixed IP
IPv4 Subnet Mask：If A2n uses static IP, please give it a subnet mask
IPv4 Default Gateway：If A2n uses static IP, please give it a Gateway address
IPv4 DNS Server：If A2n uses static IP, please set DNS IP address
3) WLAN Setting (IPv6)
Internet Connection Type： Static IP or DHCP client
IPv6 Address： If A2n uses static IP, please give it a fixed IP
IPv6 Default Gateway：If A2n uses static IP, please give it a Gateway address
IPv6 DNS Server：If A2n uses static IP, please set DNS IP address
4) STP Setting
Enable STP Mode：Enable or disable the STP service.
5) WAN/LAN Interface Assignment
Ethernet/Radio0 (2.4G)/Radio1 (5G) ：LAN interface or WAN interface, only work in
gateway mode.
Enable NAT Mode：If NAT Mode is set to "Disabled" then the AP will not perform any
network address translations and all IP traffic will be passed from the wireless clients to
the DS (Ethernet) port or wireless bridge (802.11a radio) without any modification. If
NAT Mode is set to "Enabled" then the AP will perform network address translations on
all traffic being passed from the wireless clients to the DS ( Ethernet) port or wireless
bridge (802.11a radio). The NAT will translate IP traffic address's between the wireless
client subnet and the DS subnet.
6) LAN Setting (IPv4)
LAN IP Address：IP address of local area network.
LAN IP Address Mask：IP address mask of local area network.
7) Ethernet Setting
Ethernet Mode：Auto/manual mode.
Ethernet Duplex：AP Ethernet duplex mode (Full/Half).
To Next Page
Loading...
