2. Technical Description
20
AL-2600: This module is used for branch and termination of RS-422/485 networks. For each
network node, an AL-2600 is required. The AL-2600 that is at the ends of network must be
configured with termination, except when there is a device with active internal termination, the rest
must be configured without termination.
AL-2301: Two shielded twisted pairs cable without connectors, used for networks based on RS-485
interface, with 1000 meters of maximum length.
AL-2306: Two shielded twisted pairs cable without connectors, used for networks based on RS-485
interface, with 500 meters of maximum length.
AL-2319: Two RJ45 connectors for programming the CPUs of the Nexto Series and Ethernet point-
to-point with another device with Ethernet interface communication.
AL-1729: RS-232C standard cable with one RJ45 connector and one DB9 male connector for
communication between CPUs of the Nexto Series and other Altus products of the DUO Series,
Piccolo Series and Ponto Series.
AL-1748: RS-232C standard cable with one DB9 male connector and 1 DB9 female connector for
communication between CPUs of the Nexto Series and Altus products of the Cimrex Series.
AL-1752: RS-232C standard cable with two DB9 male connectors for communication between
CPUs of the Nexto Series and Altus products of the H Series and iX series.
AL-1753: RS-232C standard cable with one DB9 male connector and one DB25 male connector for
communication between CPUs of the Nexto Series and Altus products of the H Series.
AL-1754: RS-232C standard cable with one DB9 male connector and one DB9 female connector for
o communication between CPUs of the Nexto Series and Altus products of the Exter Series or Serial
port, RS-232C standard, of a microcomputer.
AL-1761: RS-232C standard cable with two DB9 male connectors for communication between
Nexto Serie CPUs and Altus products of the AL Series.
AL-1762: RS-232C standard cable with two DB9 male connections for communication between
Nexto Series CPUs.
AL-1763: Cable with one DB9 male connector and terminal block for communication between CPUs
of the Nexto Series and products with RS-485/RS-422 standard terminal block.
NX9202/NX9205/NX9210: Cables used to interconnect the bus expansion modules.
To Next Page
Loading...
General