4. Configuration
226
Connection status of client 02
Client 02 event queue status:
FALSE – OK
TRUE – Queue limit exceeded
Client 02 event counter on queue
Table 4-161. Diagnostics via SNMP
(1)
These diagnostics was not available at the CPUs NX3004 and NX3005.
ATTENTION:
Items Ethernet NET2, SNTP and SOE are available only for CPUs NX3020 and NX3030
Configuration
SNMP settings can be changed through the web page, in the CPU Management tab in the SNMP
menu. To access the settings, you must first log in, as shown in Figure 4-119.
Figure 4-119. SNMP Login screen
After successful login, the current state of the service (enabled or disabled) as well as the user
information SNMPv3 and communities for SNMPv1 / v2c can be viewed.
The user can enable or disable the service via a checkbox at the top of the screen.
It’s also possible to change the SNMPv3 information by clicking the Change button just below the
user information. Will open a form where you must complete the old username and password, and
the new username and password. The other user information SNMPv3 cannot be changed.
To change the data of SNMPv1/v2c communities, the process is similar, just click the Change button
below the information community. A new screen will open where the new data to the rocommunity
fields and rwcommunity will be inserted. If you fail any of the fields blank, their community will be
disabled. That way, if the user leaves the two fields blank, access to the SNMP agent will only be
possible through SNMPv3.
To Next Page
Loading...
General