LW500A/LW600A PULSED Nd:YAG LASER
990-539 xi
CAUTION
Keep water and water containers away from the Laser.
Water spilled on the Laser can cause a short circuit, electrical shock, or fire.
Use proper tools (wire strippers, pressure wire connectors, etc.) for terminations of the
connecting cables.
Do not nick the wire conductor. Doing so can cause a short circuit, electric shock, or fire.
Install the Laser on a firm, level surface.
Injury may result if the Laser falls over or drops from an uneven surface.
Keep combustible matter away from the Laser.
Laser spatter can ignite combustible materials. If you cannot remove all combustible materials,
cover them with a non-combustible material.
NEVER apply the laser beam to combustible materials.
To avoid the risk of fire, never apply the laser to flammable or combustible materials.
When operating the Laser, do not cover it with a blanket, cloth, etc.
Heat generated by the operating Laser may ignite a blanket or cover.
Do NOT use the Laser for purposes other than processing metal.
Use of the Laser on other materials, or in a manner other than specified may cause fire or
electrical shock.
Wear protective gear when operating the Laser.
Wear protective gear such as protective gloves, long-sleeved jacket, leather apron, etc. so that
Laser spatter will not burn the skin.
Keep a fire extinguisher nearby.
Make sure there is a fire extinguisher in or near the Laser shop in case of fire.
Regularly inspect and maintain the Laser.
Regular inspection and maintenance is essential for safe operation and long life of the Laser.
If you see any damage, make necessary repairs before operating the Laser.
To Next Page
