PN 305892901, Rev S
Unpacking and Inspecting the Equipment
Remove any packing material from the 3050-RM Moisture Analyzer shipping
crate. Check for damage. If equipment is damaged, notify the carrier and
contact AMETEK (https://www.ametekpi.com/customersupport/aftermarket)
immediately if parts are missing or damage is found, and to verify if damaged
parts will require replacement prior to safely installing and operating the ana-
lyzer/equipment.
Tools, Equipment, and Supplies Required for
Installation
To install the analyzer you need the following tools, equipment, and supplies:
• Set of open-end wrenches for ttings.
• Set of metric hexagonal wrenches.
• Set of ball drivers.
• Wire cutters, strippers, and crimpers.
• Flat blade instrument screwdriver.
• Soft, nonabrasive cloth.
• Wrist strap (for grounding).
• Detergent-based leak detector (Snoop® or another suitable leak detection
agent is permissible).
2-4 | 3050-RM Moisture Analyzer
To Next Page
Loading...
