Moisture Unit
Select Unit
The units for the moisture readings can be selected from a list. Pressing
Enter at the Select Unit prompt displays the list. If a dew/frost point is
selected, you must enter a value for the process pressure in units of kPa.
If you change the moisture units, remember to make the necessary
changes to the Alarm and Analog Range settings.
Figure 3-6.8.
Moisture Unit sub-menu.
Config
PPmV
Centigrade
Fahrenheit
lbs/mnscf
mg/Nm³
ppmW
Moisture Unit
Select Unit
PPMV
Centigrade
Fahrenheit
Pressure (KPa)*
Pressure (KPa)*
PN 305892901, Rev S
Controller/Interface | 3-13
To Next Page
Loading...
