PN 305892901, Rev S
Personnel and Equipment Safety Information
This section describes important safety information to avoid personal injury and dam-
age to the equipment while installing, operating, maintaining, or servicing the equip-
ment. All safety regulations, standards, and procedures at the analyzer location must
be followed.
All personnel involved with the installation, start-up, operation, maintenance, service, or
troubleshooting of the analyzer must review and follow these Warnings and Cautions.
Do Not Operate without Covers
To avoid electric shock or re hazard, do not operate this product with covers
or panels removed.
Use Caution When Lifting
Use caution when lifting the analyzer from its crate.
Use Proper Attire
Equipment is hot, user should wear protective groves while handling the
equipment.
Use Proper Wiring
To avoid re hazards, use only the wiring specied in the “Installation and
Start-Up” chapter of this manual.
Avoid Electrical Overload
To avoid electrical shock or re hazard, do not apply a voltage to a terminal
that is outside the range specied for that terminal.
Ground the Product
Follow the grounding instructions provided in the “Installation and Start-Up”
chapter of this manual. Before making connections to the input or output
terminals of this product, ensure that the product is properly grounded.
Contents | ix
To Next Page
Loading...
Need help?
General
