Ametek 3050-RM

Verify Key
Use the Verify key to dene on-demand verify settings.
Hold Outputs
Enable
Select this function to hold the output at the last valid reading during
a verify.
Disable
Select this function to allow the output to change during a verify.
Adjust Oset
Enable
Select this function to adjust the span at the end of a verify cycle.
Disable
Select this function if you do not want to adjust the span.
Verify
This function initiates a verication cycle.
Abort
This function aborts a verify cycle and returns the analyzer to normal op-
eration.
Figure 3-3.
Main Menu, Verify key.
VERIFY
Hold Outputs
Enable
Disable
Adjust Span
Verify
Enable
Disable
Abort
PN 305892901, Rev S
Controller/Interface | 3-3