PN 305892901, Rev S
Parameters on the Device Communications tab include:
Baud Rate
Select the baud rate at which data will be transferred.
RS-485
Identies the analyzer’s address and the type of serial communication
cable that is being used.
Address
Type the network address for the analyzer being connected.
Two-Wire RS-485
Click if you are using a 2-wire cable.
Four-Wire RS-485
Click if you are using a 4-wire cable.
Saving Your Settings
To save settings on the Device Communications tab, click Apply.
To save settings and exit the program, click Apply+Exit.
To abort changes you have made, click Cancel+Exit. This will close the Con-
gurator Software program.
3-20 | 3050-RM Moisture Analyzer
To Next Page
Loading...
