Working From the AMETEK 3050 UHP Congurator Software
The Congurator Software provides a graphical user interface to set up param-
eters for either a single analyzer or multiple analyzers.
Although you can set and view parameters for multiple analyzers
using the 3050 Congurator Software, you can only work with one
analyzer at any time.
UHP Congurator Software Installation
1. Insert the Congurator Software CD into CD ROM drive.
2. The installation program should begin to run immediately. If it does not
start automatically, click RUN... from the Windows Start menu. Type the
drive letter, followed by a colon ( : ) and a backslash ( \ ) and the word
“setup.exe” (d:\setup.exe) and click OK to start the installation program.
3. Follow the instructions on the subsequent screens to complete the instal-
lation. When you get to the Setup Complete screen, click Finish to com-
plete the installation. The default location for the 3050-RM UHP software is
in the AMETEK, Inc. folder.
Turn o all power saving modes.
PN 305892901, Rev S
Controller/Interface | 3-15
To Next Page
Loading...
Need help?
General
