Ammann Rammax 1515-M - Operating Fluids �7; Noise and Vibration Specifications �7; Noise Specification �7

27
Rammax 1515-M/-MC/-MI/-MCI
Index: a; Issued 08/2010
Operating uids
Quantity Specication Ex-factory
Fuels:
Diesel l 22
EN 590 oder DIN 51601
- DK oder BS 2869 A1 / A2
oder ASTM D 975 - 1D/2D
Hydraulics:
Hydraulic oil
Standard relling l 55
DIN 51524-2 HLP 46
Fuchs Renolin B15
VG46
ISO 6743-4 HM 46
ISO 6743-6 CKC 46
Bio-hydraulic oil
relling
l 55
ASTM D-6046-98a: PW1,
TW1, TS1
Panolin HLP Synth
46
Lubricants:
Engine oil l 3
ACEA E2/B3/A3
Fuchs Titan univer-
sal 15W40
API CG-4/SJ
MIL-L-2104E
Bearing grease per
bearing
gr ca.100 KHLPF2R Aeronix MoS2
Noise and vibration specications
The noise and vibration specications listed below in ac-
cordance with the EC Machine Directive in the draft (93/68/
EEC) were determined under operating conditions typical for
the machinery in question with vibration over a specied travel
surface (DIN 45635).
In operational application, deviating values may result depen-
ding on the prevailing operating conditions.
Noise specication
The noise emission specication stipulated in accordance
with Annex 1, Section 1.7.4.f of the EC Machine Directive
is as follows:
Noise level at operator position LpA : 86,9 dB(A)
Sound power level LWA : 102,7 dB(A)
These noise emission values were determined in accordance
with ISO 6081 for the sound pressure level (LpA) and ISO
3744, DIN 45635, for the sound power level (LWA).
technical data