Ammann Rammax 1515-M - Vibration Switch; Setting up the Transfer Addresses

61
Rammax 1515-M/-MC/-MI/-MCI
Index: a; Issued 08/2010
Vibration switch
This switch is used to switch the vibration function On and Off.
The vibrations switch has three switch positions:
Vibration switched off (Fig. SE25)
Vibratate forwards (Fig. SE26)
Vibrate backwards (Fig. SE27)
Fig. SE25 Vibration switched off Fig. SE26 Vibratate forwards Fig. SE27 Vibrate backwards
The vibration switch has a locking function. It remains in the
position that it was switched to until it is moved again.
Reversing the rotational direction
Switch the vibration lever into the opposite position to reverse
the vibration shaft's rotational direction.
The vibration shaft will be braked before it starts to accele-
rate in the opposite direction. This procedure takes a few mo-
ments.
NOTE
Change the rotational direction of the vibration shaft during the
compacting work on slopes and declines so that it is always
against the slope. This will increase the machine's climbing abi-
lity and the traction.
Setting up the transfer addresses
The remote infrared controller transfer the control command
to the machine via an infrared signal. There are ten different
transfer addresses. The same address must be selected on
both so that the machine can react to the control command
from the remote infrared controller. The adjustment wheels
•
•
•
controls