Ammann Rammax 1515-M - Operating the Machine; Initial Commissioning; Checking before Starting Work; Always Check the Following before Using the Remote Infrared Controller

66
Rammax 1515-M/-MC/-MI/-MCI
Index: a; Issued 08/2010
Initial commissioning
Remove the lm from the machine and dispose of it in compli-
ance with the national regulations.
Enter the data listed on Page 4 of this operating manual. The
operating manual will help you set up the machine.
The machine is ready for use when it leaves the factory. The
hydraulic oil and the engine oil tanks have already been l-
led.
The fuel tank has not been lled completely. Rell with fuel
before starting work.
Checking before starting work
Always check the fuel and rell whenever necessary before
starting work. You will nd the fuel specications in the "Tech-
nical specications“ chapter.
Check that the machine's safety devices are working. Only
use the machine if the safety devices are working correctly.
Check that the screw connections are tight. Any loose compo-
nents will be damaged when the machine is used.
Check that all of the accesses and openings have been closed
or locked. The vibrations will damage any open covers or aps
when the machine is being used.
Always check the following before using the remote
infrared controller
Check the address settings of all of the machines at the site
before using them. You must ensure that each address is only
used once per machine.
Packing
Machine data
Ready for use
Check the operating medium
levels
Check the safety devices
Check the screw connections
operating the Machine