Ammann Rammax 1515-M - Storing; Overwintering the Machine; Storing the Machine; Overwintering; Storing the Machine for a Longer Period

94
Rammax 1515-M/-MC/-MI/-MCI
Index: a; Issued 08/2010
storing / overwintering the Machine
Storing the machine
Move the operating lever into the neutral position
Fit a chock under the machine so that it cannot roll away
Remove the ignition key. This prevents unauthorised
persons starting up the machine.
Overwintering / storing the machine for a longer period
Store the machine, if it is not going to be used for more than
2 weeks. It is possible to store the machine outdoors. Please
note, that corrosion and decay of the components are acce-
lerated outdoors.
BEWARE!
Fire danger!
Never operate the machine if the engine and exhaust are hot.
Inammable materials can ignite in the vicinity of these parts.
Therefore
Do not store the machine near to combustible materials►
Only cover the machine after the engine and exhaust have
cooled down.
►
Take the following precautions when storing the machine
Earth, clay and mud often remain on the scraper bars and
the drums. It is very difcult to remove this dirt after it has
dried.
Clean the machine thoroughly.
Damaged components and loose screw connections are
a safety risk. These defects are often forgotten when
restarting the machine.
Service the machine. Carry out the specied maintenance
work. Check all screw connections for a rm t. If neces-
sary, retighten loose connections.
Old and polluted engine oil ows less easily than new oil.
Furthermore, low temperatures decrease the uidity.
Check the degree of pollution of the engine oil. Drain pol-
luted engine oil and rell with new oil. Let the engine idle
for about 5 minutes so that the oil can reach all parts.
Low temperatures accelerate battery discharging. The
•
•
•
•
►
•
►
•
►
►