Ammann Rammax 1515-M - Refilling with Engine Oil

64
Rammax 1515-M/-MC/-MI/-MCI
Index: a; Issued 08/2010
NOTE
The hydraulic system probably has a leak if the hydraulic tank
oil level drops often and severely.
Inform your service workshop.►
Rell with hydraulic oil after:
Switching the machine off and removing the ignition key.
Opening the engine protector:
Opening the tank cover.
Rell with hydraulic oil and check the fuel display lling
level as well.
Relling with engine oil
Use the engine dip-stick to check the level of the engine oil. It
is tted on the right side of the engine (Fig. BA8).
Fig. BA8 Engine oil dip-stick location
Check the engine oil level as follows:
Open the engine protector:
Pull out the engine oil dip-stick and use a clean cloth to
wipe it clean.
Put the engine oil dip-stick back in.
Pull the dip-stick back out and read the level. The level
must lie inbetween the two marks.
Rell with engine oil after:
Opening the relling opening cover (Fig. BA9).
Rell with engine oil and check the lling level as well.
Repeat the previous process until the level lies inbetween
the marks.
Close the oil relling opening cover.
Relling with engine oil has been completed.













refilling