100
Rammax 1515-M/-MC/-MI/-MCI
Index: a; Issued 08/2010
Error codes
Error
code:
Meaning: Cause: Solution:
FErr 1 An unknown signal has
been received.
This message appears
at a time when the
connection between the
machine’s control device
has been physically bro-
ken, for example when a
cable breaks or a contact
loosens.
Check the cables to the
machine’s control device.
Replace defective parts.
FErr 2 For a certain period no
more dispatches have
been received from the
machine’s control device.
This error indicates a bro-
ken cable.
Check the cables to the
machine’s control device.
Replace defective parts.
FErr 3 Internal processing is too
slow or too complex.
There may be a hard-
ware defect in the recei-
ver module of the cockpit
display.
Contact your service
facility.
FErr 4 Internal processing is too
slow or too complex.
There may be a hard-
ware defect in the recei-
ver module of the cockpit
display.
Contact your service
facility.
Err 1 Signal is received from
the infrared transmitter
even though the hand
controls are active.
Start-up was done from
the hand switch box, so
operation through the
infrared transmitter is not
possible.
This error disappears
as soon as no infrared
signal is received.
Err 2 Signal is received from
the hand controls even
though the infrared trans-
mitter is active.
Start-up was done from
the infrared transmitter,
so operation through the
hand switch box is not
possible.
This error disappears
as soon as no signal is
received from the hand
controls.
Machine must be ope-
rated with the infrared
transmitter.
Turn the machine off and
start it again with the
hand switch box.
Err 3 Valid infrared signal
received, but address is
wrong.
Addresses from the
transmitter and receiver
do not match
Check and match the
addresses between the
transmitter and the cont-
rol device.
Match the addresses
from the sender and
receiver (0-9)
appendix
To Next Page
Loading...
