Ammann Rammax 1515-M - Maintaining the Machine; Maintenance Plan

77
Rammax 1515-M/-MC/-MI/-MCI
Index: a; Issued 08/2010
Maintenance plan
Description: Remarks: Page:
Every day
• Check engine oil level • Observe gauge marking 35
• Check hydraulic oil level • Oil sight glass 35
• Check hydraulic lter element
• Check fuel level • Sight glass 36
• Check air lter 38
• Diesel engine see Hatz 2G40 operating manual (Annex)
After 25 hours of operation
• Check all bolts and screws for tightness Tightening torques
• Change the fuel lter 36
• Diesel engine see Hatz 2G40 operating manual (Annex)
• Replace high-pressure lter element
After 75 hours of operation
• Replace air lter cartridge (earlier, if necessary) 40
• Service the battery Grease the terminals 37
• Attention! : engine oil for the diesel engine (see
Hatz 2G40 operating manual)
(see Annex)
Every 100 operating hours
• Clean or replace air lter cartridge (earlier, if necessary) 38
• Service the battery 43
Every 250 operating hours
• Check the oil level in the travel drives
• Check all bolts and screws for tightness Tightening torques 41
• Drain water from diesel line lter or replace lter 36
• Inspect all diesel lines for leaks 36
Every 500 operating hours
• Diesel engine see Hatz 2G40 operating manual (see Annex) 40
• Change the transmission oil in the travel drives (at least every 6 months)
• Replace high-pressure lter element (2nd service)
Every 1000 operating hours
• Change the hydraulic oil (at least 1x per year) 40
• Replace high-pressure lter element
• Change the fuel lter (after the 3rd service, at least
1x per year)
36
• Replace suction lter 40
As required
• Adjust stripper 41
• Check all bolts and screws for tightness Tightening torques 41
• Engine conservation see Hatz 2G40 operating ma-
nual (Annex)
Maintaining the Machine