Ammann Rammax 1515-M - Driving the Machine up Onto the Transport Vehicle

74
Rammax 1515-M/-MC/-MI/-MCI
Index: a; Issued 08/2010
Fig. MT7: Material fatigue
Fig. MT6: Lifting equipment trapped
in place
Fig. MT8: Cracks
WARNING!
Danger from falling objects!
Damaged transport hoops can break under load. Machines can
be dropped during the loading and unloading process.
Therefore
Always check the state of the transport hoop and the foam
plate before loading.
►
Change the foam plate immediately if you nd that it is da-
maged.
►
Remove any gravel or stones that have collected between
the transport hoop and complete frame.
►
Load the machine as follows:
Put chocks under the transport vehicles wheels.
Lock the shut down yoke in place.
Attach the lifting equipment to the machine's transport
hoop.
Load the machine.
Remove the lifting equipment that was used after nishing
the loading.
Driving the machine up onto the transport vehicle
Use a suitable driving ramp to move the machine onto the
transport vehicle. Only use driving ramps:
that are not damaged and are free of dirt, oil, grease and
ice
that have sufcient load bearing capability,
have a suitable non-slip surface so that the machine will
not slide off.
of sufcient length so that the maximum incline angle is
30°
Always abide by the climbing capability of the machine. It must
never be exceeded.





•
•
•
•
transporting the Machine