67
Rammax 1515-M/-MC/-MI/-MCI
Index: a; Issued 08/2010
CAUTION!
Danger of injury!
Different addresses must be set up on the machines if you are
going to use several machines simultaneously at the same site.
Otherwise it might happen that you nd yourself controlling
several machines from a single remote infrared controller and
injuring other people.
Therefore:
Always check the transfer addresses on the machines that
you will be using before starting work.
►
Never use more than ten machines simultaneously in in-
frared mode.
►
Starting the machine
Check the surrounding area for possible sources of danger
before starting work with the machine.
Unlock the safety yoke.
Set the engine revs adjustment lever to full power.
Open the cockpit cover and insert the ignition key in the
ignition lock.
Turn the ignition key to Position 2.
The machine is now at "Stand-by“. It is ready to start.
NOTE
Stop the start process if the diesel engine has not caught after
15 seconds.
The diesel engine is tted with a starter protection module to
protect the starter. The diesel engine cannot be restarted imme-
diately after start attempt.
Switch the ignition off and wait for 30 seconds.
Restart the engine.
Contact your service workshop if the diesel engine does not
catch after several attempts.
►
►
►
Select the control mode that you want to work with:
operating the Machine
To Next Page
Loading...
