Ammann Rammax 1515-M - Note During the Maintenance; Changing the Engine Oil and the Oil Filter

78
Rammax 1515-M/-MC/-MI/-MCI
Index: a; Issued 08/2010
Note during the maintenance
Components must only be replaced by original spare parts.
Changing the engine oil and the oil lter
Change the engine oil in a new machine after 50 running
hours. Change it every 250 running hours afterwards or after
a year at the latest. Only use the engine oil that corresponds
to the specications listed in the "Operating materials“ table.
Always change the oil lter as well when you change the en-
gine oil.
Never start the engine when the oil has been drained from it.
ENVIRONMENT
Escaping lubricants harm the ground!
Working with lubricants endangers the ground. Lubricants that
escape from defective machines, complete plants, tanks or
through carelessness can pollute the ground and the ground
water.
Therefore:
Never spill any lubricant when relling.
Collect any lubricant that escapes or spills and dispose of it
in compliance with the national regulations!
Prevent any escaped lubricant from seeping into the ground.
►
►
►
NOTE
Let the diesel engine run for a few minutes before draining off
the engine oil. The oil will drain out better if it is hot.
Proceed as follows:
Place the machine on level ground.
Undo the clip
2
on the oil drain hose
3
(Fig. MW1).


Maintaining the Machine