53
Rammax 1515-M/-MC/-MI/-MCI
Index: a; Issued 08/2010
The vibration lever has a locking function. It remains in the
position that it was switched to until it is moved again.
Reversing the rotational direction
Switch the vibration lever into the opposite position to reverse
the vibration shaft's rotational direction.
The vibration shaft will be braked before it starts to accele-
rate in the opposite direction. This procedure takes a few mo-
ments.
NOTE
Change the rotational direction of the vibration shaft during the
compacting work on slopes and declines so that it is always
against the slope. This will increase the machine's climbing abi-
lity and the traction.
Engine revs setting lever
Use the setting lever to linearly control the engine revs. The
engine can be switched off after the revs have been reduced
to the minimum. The setting lever must be set to full power in
order to build up the required machine operating pressure.
Fig. SE9 Stop engine
Fig. SE10 Maximum revs / full
power
controls
To Next Page
Loading...
