68
Rammax 1515-M/-MC/-MI/-MCI
Index: a; Issued 08/2010
Starting up using the manual controls
Turn the ignition key to Position 3.
The engine starts.
Starting up using the remote cable controller
Press the "Start“ button until the engine starts.
The engine starts.
Starting up using the remote infrared controller
Press the "Start/Stop“ switch to the "Start“ position on the
right until the engine starts.
The engine starts.
Compacting subsoil
Several passes will be needed until the subsoil is fully com-
pacted. The number of passes needed depends on the
composition of the subsoil. Machines tted with "Ammann
Compaction Expert (ACE)“ display when the subsoil has been
compacted. Table MBT1 shows the approximate number of
passes needed for a 30 cm layer:
Subsoil / Ground type Passes needed
Gravel, sand approx.3 - 5
Mixed ground approx.3 - 5
Coarse clay, clay approx.3 - 5
MBT1: Making a pass
Move the machine onto the ground that has to be compacted.
Switch fast traverse on if you have to cover a long distance.
Switch fast traverse off again before you start the compac-
ting.
Compacting a level surface
The vibration shaft's rotational direction is not important on
a level surface.
Switch one of the two vibration functions on.
operating the Machine
To Next Page
Loading...
