Ammann Rammax 1515-M - Maintenance and Repair Personnel Requirements; Trainees; Trainees Operating the Machine; Trainees Maintaining the Machine

31
Rammax 1515-M/-MC/-MI/-MCI
Index: a; Issued 08/2010
Maintenance and repair personnel requirements
Only qualied construction machinery drivers or mecha-
nics are allowed to undertake the maintenance and repair
work.
Only specialists with hydraulic training are allowed to
undertake the work on the hydraulic system.
Only specialists with electrics or electronics qualica-
tions are allowed to undertake the work on the electrical
system.
Trainees
Trainees operating the machine
Trainees under the age of 18 are only permitted to operate the
machine under supervision and only for training purposes.
Trainees maintaining the machine
Trainees under the age of 18 are only permitted to maintain
the machine under supervision and only for training purposes.
Only specialists holding the relevant qualications are allowed
to undertake the work on the electrical or hydraulic systems.
Safety equipment
The machine is equipped with various safety equipment. The
function of the safety equipment must be checked before ope-
rating the machine. The machine must never operated with
defective or missing safety devices. Do not disassemble, by-
pass or link out safety devices. Defective safety devices must
be replaced immediately. The machine is equipped with the
following safety equipment.
Shut down yoke
The shutdown yoke is tted at the rear of the machine below
the operating unit. It has two switch positions: "Locked“ (Fig.S1)
and "Unlocked“ (Fig.S2).
•
•
•
safety