EasyManua.ls Logo

Ammann Rammax 1515-M - Page 95

Ammann Rammax 1515-M
111 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
95
Rammax 1515-M/-MC/-MI/-MCI
Index: a; Issued 08/2010
storing / overwintering the Machine
battery can be damaged by deep discharge, it is not regu-
larly charged during machine operation.
Remove the battery and clean the exterior surfaces.
Charge the battery monthly when in storage. Also, fully
charge the battery before starting the machine up again.
Condensation can form in the hydraulic oil tank and fuel
tank during storage. The inner walls of the tanks are the-
refore endangered by corrosion.
Fill hydraulic oil into the hydraulic oil tank up to just below
the maximum level. Fill diesel fuel into the fuel tank up to
just below the maximum level. Then move the machine
over uneven ground. The inner walls are now moistened
with the liquids and protected against corrosion.
Moisture can penetrate into the engine through the air
lter unit and exhaust pipe.
Cover the intake manifolds of the air lter unit and ex-
haust pipe with an adhesive tape. Don't forget to remove
the adhesive tape before starting up the machine again!
Diesel fuel loses its uidity and thickens at temperatures
starting from -15°C/5°F. This clogs up the fuel lter and
the lines.
Add appropriate additives to the Diesel fuel, before using
it at lower temperatures.
Humidity from the air can condense and corrode sliding
engine parts if the engine is not used for a long time.
Run the engine for 5 minutes every 2 to 3 months. Do not
forget to remove the adhesive tape from the air lter unit
and exhaust pipe! Additives must be added to the Diesel
fuel at temperatures below -15°C!

Table of Contents

Related product manuals