EasyManuals Logo

AmScope MU USB3.0 User Manual

AmScope MU USB3.0
147 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #145 background imageLoading...
Page #145 background image
145
MU Series (Windows)
Users Manual
Troubleshoong
Common Issues
Symptom Cause Remedy
ISSUES
One side of the eld
of view is darker
The nosepiece is misaligned Turn the nosepiece unl it clicks into place
Stains or dust has accumulated on the objecve,
eyepieces, or base lens
Clean all lenses with lens cleaner or a lint free non-
abraisive cloth
The port is not fully open If your microscope has a shuer or prism switch
on it to open a trinocular port to allow light to the
camera, remove the camera and check that the pin
or switch is fully adjusted and fully aached. If not,
please contact info@amscope.com with your SKU
and order number for assistance and warranty in-
formaon for your microscope.
Obstrucons are
observed in the eld
of view
Stains, dust, or dirt has accumulated on the
specimen
Clean the slide or use a new specimen if sample is
destroyed.
Stains, dust, or dirt have accumulated on a lens Clean both ends of the reducon lens and the lens
on the camera body with lens cleaning soluon
and non-abrasive opcal lens cloth.
Unclear Image Stains, dust, or dirt have accumulated on a lens Clean both ends of the reducon lens and the lens
on the camera body with lens cleaning soluon
and non-abrasive opcal lens cloth.
Stains, dust, or dirt have accumulated on a lens
in the microscope
Remove the camera and use a can of compressed
air to remove any dust, dirt, or debris from the
port it sits in, and ensure any and all objecves are
cleaned using lens cleaning soluon and a non-
abrasive opcal lens cloth.
The sample is not in focus Not all microscopes will have the camera and the
eyepieces in focus at the same me, and may re-
quire refocusing while looking at the sample on the
computer screen to ensure the camera view is fo-
cused. Adjustment must be done on the trinocular
port (if adjustable) or the microscope’s main focus-
ing knobs.
One side of the eld
of view is dark or the
image moves while
focusing
The sample is not secured and centered under
the microscope
Secure the sample to the stage.
The objecve lenses of the microscope aren’t
properly posioned or secured into place
Ensure that the objecve lenses of your micro-
scope are locked into posion.
The eld of view is
not bright enough
The microscope light is too dim Turn the dimmer dial or knob up on the micro-
scope’s illuminaon source, or use a stronger light.
The exposure seng is not set properly in the
soware
Turn “Auto Exposure” on, if it is not already on, and
raise the “Exposure Target. Alternavely, turn it
o and adjust the “Exposure Time” seng.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the AmScope MU USB3.0 and is the answer not in the manual?

AmScope MU USB3.0 Specifications

General IconGeneral
BrandAmScope
ModelMU USB3.0
CategoryMicroscope
LanguageEnglish

Related product manuals