Anritsu MT1810A - Page 127

7.2 Common Commands
7-9
7
Remote Commands
CND?
Response <mainframe>,<slot1>,...,<slot644>,<usb1>,...,<usb1274>
<mainframe> Previous function omitted
<slotx> Previous function omitted
<usb x>=<module>,<serial>,<fpga1>[,<fpga2>],<boot>,<application>,<opt>
x indicates a USB number. The USB number is 1 to 127.
<module>=<STRING RESPONSE DATA>
XXXXXXXXX (FIX9) Refer to Table 7.2.1-2 “Option Character
Correspondence Table”.
Note:
NONE is output if no module is installed.
<serial>=<STRING RESPONSE DATA>
XXXXXXXXXX (FIX10) 0000000000 to 9999999999
Serial number
Note:
“-------------” is output if no module is
installed.
<fpga1>[,<fpga2>,.....] = <STRING RESPONSE DATA>
XXXX.XX.XX (FIX10) 1.00.00 to 9999.99.99
FPGA ve rsion
<boot>=<STRING RESPONSE DATA>
XXXX.XX.XX (FIX10) 1.00.00 to 9999.99.99
Logic Boot version
Note:
“-------------” is output if Logic boot is not
installed.
<application>=<STRING RESPONSE DATA>
XXXX.XX.XX (FIX10) 1.00.00 to 9999.99.99
Logic Application version
Note:
“-------------” is output if Logic Application
is not installed.
<opt>=<STRING RESPONSE DATA>
XXXXXX (FIX6) Option number
OPTXXX:
Note:
All installed options are output.
NONE is output if no option is installed.
Function Queries the software status of the MP1861A.
Example > CND?
< CND 6201234567, 1.00.00, 1.00.20,OPT301,OPT302,
1.00.00, 1.00.00,OPT 12,
・・・,
MP1861A,6201234571, 1.00.00, 1.00.00,1.00.00,OPT002,