Anritsu MT1810A - Page 159

7.4 Automatic Measurement Commands
7-41
7
Remote Commands
:SENSe:MEASure:ASEarch:SELSlot? <slot>,<interface>[,<unit>]
Parameter <slot>=<CHARACTER PROGRAM DATA>
SLOT1 to SLOT6 Slots No. 1 to No. 6
1 to 6 when using the MP1800A, 1 to 4 when using the MT1810A
USB11 to USB14 USB No.11 to 14
<interface>=<DECIMAL NUMERIC PROGRAM DATA>
1 to 4 Data1 to 4
[<unit>]=<DECIMAL NUMERIC PROGRAM DATA>
1 to 4 Mainframe Nos. 1 to 4
When using two or more MT1810A units in serial connection, specify the
mainframe number.
Can be omitted. Mainframe No. 1 is specified when omitted.
Response <boolean>=<NR1 NUMERIC RESPONSE DATA>
1 ON
0 OFF
Function Queries the ON/OFF state of Auto Search for each slot.
Example To query the ON/OFF state of Auto Search for USB No.11:
> :SENSe:MEASure:ASEarch:SELSlot? USB11,1
< 1
Compatibility Incompatible with existing models. (The parameters are different.)
:SENSe:MEASure:ASEarch:SLOT? <slot>,[<unit>]
Parameter <slot>=<CHARACTER PROGRAM DATA>
SLOT1 to SLOT6 Slots No. 1 to No. 6
1 to 6 when using the MP1800A, 1 to 4 when using the MT1810A
USB11 to USB14 USB No.11 to 14
[<unit>]=<DECIMAL NUMERIC PROGRAM DATA>
1 to 4 Mainframe Nos. 1 to 4
When using two or more MT1810A units in serial connection, specify the
mainframe number.
Can be omitted. Mainframe No. 1 is specified when omitted.
Response <interface>=<NR1 NUMERICRESPONSE DATA>
1 to 4 Data1 to 4
Note:
The interface numbers of all the data interfaces to which the Auto
Search function can be executed are returned in a
comma-separated string. 1 is returned if Auto Search for an
MP1862A is ON. If all the targets are OFF, “Parameter Error” is
returned.
Function Queries the data interface(s) to which the Auto Search function can be
executed..
Example To query the data interface(s) to which the Auto Search function for USB