•
MX269018A Analog Measurement Software Operation Manual (Remote
Control)
This manual describes how to use the MX269018A Analog
Measurement Software and MS2830A, MS2840A signal analyzer
analog signal generator via remote command.
As for MS2830A, MS2840A signal analyzer application's basic remote
control functions and its definitions of common commands, refer to
“MS2690A/MS2691A/MS2692A and MS2830A/MS2840A/MS2850A
Signal Analyzer Operation Manual (Mainframe Remote Control)”.
Document Conventions
This indicates the Signal Analyzer panel keys.
This indicates pages and sections to be referred to.
This indicates message that appears on the screen.
‘
’
This indicates reference that does not pertain to screen
messages.
“ ” This indicates reference, or jump to other section of the
manual.
Convention Used in This Manual
Throughout this document, the use of MS2830A is assumed unless
otherwise specified. If using MS2840A, change MS2830A to read
MS2840A.
To Next Page
Loading...
