3.4 TX Measurement Mode
3-43
3
Measurement
Monitor Volume
■
Summary
Sets the AF signal output level.
The value can be changed by the rotary knob.
When changed by the rotary knob, the Monitor Volume value is
displayed at the upper part of the window as Figure 3.4.5.1-2.
Figure 3.4.5.1-2 Monitor Volume Change
Note:
The value can be changed by the rotary knob when a parameter is
not selected by the Audio Generator window or the RF Signal
Generator window.
■
Setting range
0 to 100
3.4.5.2 When Audio Analyzer Option is installed
When the MS2830A-018/118 Audio Analyzer is installed, the MS2830A
has a built-in speaker. When selecting FM modulation in TX
measurement mode, the demodulated FM signals can be output from the
speaker for sweeping. Additionally, the speaker output can be monitored
by connecting a headphone, etc. to the headphone output connector.
Performs settings for the speaker or headphone. When setting
(Speaker/Headphone Out) to On on Page 2 of the main function menu,
demodulated FM signals will be output.
Speaker/Headphone Out
■
Summary
Outputs the demodulated FM signals.
■
Options
Off Stops the demodulation monitor.
On Starts the demodulation monitor.
Monitor Volume
Refer to Monitor Volume in 3.4.5.1 “When USB audio device is connected”.
To Next Page
Loading...
