3.4 TX Measurement Mode
3-55
3
Measurement
Radian
■
Summary
Displayed when Modulation is set to
M.
Displays the +Peak, –Peak, (+Peak to –Peak)/2, and RMS result of
phase transition of measured signal in radian unit.
Displays the Average and Max. Hold results when Average is set to
ON.
It is not displayed when Display Mode is Carrier.
Depth
■
Summary
Displayed when Modulation is set to AM.
Displays the +Peak, –Peak, (+Peak to –Peak)/2, and RMS result of
modulation index of measured signal in % unit.
Displays the Average and Max. Hold results when Average is set to
ON.
It is not displayed when Display Mode is Carrier.
DCS Code (Normal / Inverted)
■
Summary
Displays the DCS code analysis result for measured signal with
three-digit octal notation.
Displayed when DCS Analysis is set to Normal or Inverted.
The first code of the displayed result is displayed when the code that
corresponds to the 83 Standard Code defined in TIA-603-C is
detected. If no code is detected, the result display will be ***.
The subsequent codes in parentheses that correspond to codes other
than the 83 Standard Code are displayed.
It is not displayed when Display Mode is Carrier or Modulation.
To Next Page
Loading...
