Arris NVG599 - CHAPTER 4 - Command Line Interface

101
CHAPTER 4 Command Line Interface
The NVG599 VDSL2 Gateway operating software includes a command line interface (CLI) that lets you access
your NVG599 device over a Telnet connection. You can use the command line interface to enter and update the
unit’s configuration settings, monitor its performance, and restart it.
This chapter covers the following topics:
 “
Overview” on page 103
 “Starting and Ending a CLI Session” on page 105
 “Using the CLI Help Facility” on page 106
 “About SHELL Commands” on page 106
 “SHELL Commands” on page 107
 “About CONFIG Commands” on page 118
 “CONFIG Commands” on page 121
 “Debug Commands” on page 178