Arris NVG599 - Physical Interfaces Commands

Administrator’s Handbook
150
set management lan-access wan-cpe-mgmt-block [ off | web | all ]
Blocks management of the device from the LAN via the Web or all interface(s).
TR-064
DSL Forum TR-064 (“LAN Side CPE Configuration”) is an extension of UPnP (Universal Plug-and-Play). It defines
more services to locally manage the NVG599 device. While UPnP allows open access to configure the device's
features, TR-064 requires a password to execute any command that changes the device's configuration.
set management lanmgmt enable [ off | on ]
Turns TR-064 LAN-side management services on or off. The default is off.
Physical Interfaces Commands
DSL interfaces
set physical dsl enable [ off | on ]
Turns the physical DSL interface off or on. Default is on.
set physical dsl dsl-mode [ auto | single | bonded ]
Sets the mode for the DSL connection, whether a single line or bonded. If the default auto is set, the device
will try both single and bonded, attempting to detect and lock on the mode in use.
set physical dsl loopback [ off | on ]
Turns the DSL loopback mode off or on. Default is off.
set physical dsl annexm [ off | on ]
Turns optional DSL Annex M off or on. Default is off. If enabled, data rates can be as high as 12 or 24 Mbit/s
downstream and 3 Mbit/s upstream depending on the distance from the DSLAM to the customer's premises.
set physical dsl modulation auto [ off | on ]
Turns automatic DSL modulation off or on. Default is off.
set physical dsl modulation vdsl2 [ off | on ]
Turns VDSL2 DSL modulation off or on. Default is on.
set physical dsl modulation adsl2 [ off | on ]
Turns ADSL2 DSL modulation off or on. Default is on.
set physical dsl modulation adsl2+ [ off | on ]
Turns ADSL2+ DSL modulation off or on. Default is on.
set physical dsl modulation annex-l [ off | on ]
Turns Annex-l DSL modulation off or on. Default is off.