143
set ip alg sip-enable [ on | off ]
Turns the SIP (Session Initiation Protocol) ALG for voice communication initiation on or off. Default is on.
set ip alg tftp-enable [ on | off ]
Turns the TFTP (Trivial File Transfer Protocol) ALG for simple file transfers and firmware updates on or off.
Default is on.
Dynamic DNS Commands
set ip dynamic-dns enable [ off | on ]
Enables or disables dynamic DNS. Dynamic DNS support allows you to use the free services of
www.dyndns.org
. Dynamic DNS automatically directs any public Internet request for your computer's name to
your current dynamically-assigned IP address. This allows you to get to the IP address assigned to your
gateway, even though your actual IP address may change as a result of a PPPoE connection to the Internet.
set ip dynamic-dns service-type [ dyndns ]
set ip dynamic-dns username myusername
set ip dynamic-dns password mypassword
set ip dynamic-dns hostname myhostname
set ip dynamic-dns retries [ 1 - 64 ]
Enables or disables dynamic DNS services. The default is off. If you specify dyndns.org, you must supply your
host name, user name for the service, and password. Number of retries defaults to 5.
Default Server Settings
set ip wan-allocation mode [ normal | defaultserver ]
Sets the WAN mode to direct your NVG599 to forward all externally initiated IP traffic (TCP and UDP protocols
only) to a default host on the LAN, otherwise this feature is disabled. Default is normal.
Link Commands
The link commands represent physical connections. Currently, port-based VLAN support is provided at this
level. Your NVG599 device is capable of adding and stripping 802.1Q tags to and from frames before
transmission on its LAN interfaces. See also “
Filter Set Commands” on page 124 and “Queue Commands” on
page 129 for more information.
set link name name type [ ethernet | ppp ]
Specifies whether the type of the link named name is ethernet or ppp.
set link name name mtu-override [ 0 - 1500 ]
Specifies whether the maximum transmission unit value should be set to other than the standard 1500. A
setting of 0 (zero) turns off override.
set link name name igmp-snooping [ off | on ]
Turns igmp-snooping off or on on the link named name.
To Next Page
Loading...
