Administrator’s Handbook
124
set conn name name dhcp-client discover-time seconds
The DHCP client parameters appear when the connection type has been set to dhcpc. The discover-time value
is in seconds; the default is 30.
set conn name name dhcp-client dns-enable [ on | off ]
Allows you to enable or disable the default behavior of acting as a DNS proxy. The default is on.
set conn name name dhcp-client dns-override [ off | on ]
Allows you to enable or disable overriding default DNS behavior. The default is off.
set conn name name dhcp-client vendor-class string
The vendor-class default information varies by model and components. This is information that identifies the
unit.
set conn name name fs-egress filterset_name
Attaches a user filterset to a connection, which is applied to transmitted packets. See “Filter Set Commands”
on page 124.
set conn name name fs-ingress filterset_name
Attaches a user filter set to a connection, which is applied to received packets. See “Filter Set Commands” on
page 124.
Filter Set Commands
Filter sets provide packet filtering and QoS configuration. Packets are identified by characteristics that allow
QoS and forwarding decisions to be made. These characteristics can be at the MAC layer, IP layer, TCP | UDP |
ICMP layer(s), or (in applicable circumstances) 802.1q/p (VLAN-tagging) layer.
Your NVG599 device is capable of adding and stripping 802.1Q tags to and from frames before transmission on
its LAN interfaces. See also “
Link Commands” on page 143 for more information.
A maximum of 8 filter sets are supported. Each filter set can have up to 8 rules configured. A maximum 8
egress queues are supported. Each queue can have up to 8 entries.
A filter set rule identifies packet attributes to match with its match parameters. It acts on these packets using
its default action parameters.
set filterset name filterset_name rule number order number
Determines order of execution of filter set rules (1 before 2, etc). If order is unspecified, the value of order is
set to 1 more than the last order in the filter set. If order is set to an already existing order value, order values
of other rules are incremented automatically.
set filterset name filterset_name rule number enable [ on | off ]
Dynamically enables or disables the specified filter set rule.
To Next Page
Loading...
