Arris NVG599 - Remote Access Commands

Administrator’s Handbook
148
set management web https-cert-cn string
Specifies a certificate from a trusted certificate authority to identify the secure Web access.
set management web idle-timeout [ 1...120 ]
Specifies a timeout period of inactivity for HTTP access to the NVG599 device, after which a user must log in to
the NVG599. Default is 5 minutes for HTTP.
set management web isp-help-desk phone_number_string
Specifies the ISP Help Desk phone number as it appears in the Web UI. For AT&T, the default is: 1-800-288-
2020.
Remote Access Commands
set management remote-access http-port [ 1 - 65534 ]
Sets the Web access port for remote access management of the NVG599. Default is port 51003.
set management remote-access http-idle-timeout [ 1...120 ]
Specifies a timeout period of inactivity for remote HTTP access to the NVG599, after which a user must log in
to the device. Default is 20 minutes for HTTP.
set management remote-access http-total-timeout [ 1...120 ]
Specifies a total timeout period of inactivity for remote HTTP access to the NVG599, after which a user must
log in to the device. Default is 20 minutes for HTTP.
set management remote-access http-max-clients number
Specifies the maximum number of client sessions for remote Web access management. Defaults to 1 (one).
set management remote-access https-port [ 1 - 65534 ]
Sets the secure Web access port for remote access management of the NVG599. Default is port 51443.
set management remote-access https-idle-timeout [ 1...120 ]
Specifies a timeout period of inactivity for secure remote HTTPS access to the NVG599 device, after which a
user must log in to the device. Default is 20 minutes for HTTPS.
set management remote-access https-total-timeout [ 1...120 ]
Specifies a total timeout period of inactivity for secure remote HTTPS access to the NVG599 device, after which
a user must log in to the device. Default is 20 minutes for HTTPS.
set management remote-access https-max-clients number
Specifies the maximum number of client sessions for secure remote Web access management. Defaults to 1.

NOTE:
You cannot specify a port setting of 0 (zero) for both the Web and Telnet ports at the same time. This would
prevent you from accessing the
NVG599.