103
Overview
The CLI has two major command modes: SHELL and CONFIG. Summary tables that list the commands are
provided below. Details of the entire command set follow in this section.
SHELL Commands
Command Description
arp Send ARP request
clear Erase all stored configuration information
clear_certificate Remove an SSL certificate that has been installed
clear_https_certkey Remove a secure HTTP certificate key value
clear_firewall_log Empty the contents of the firewall event log
clear_log Erase all stored log info in flash memory
configure Configure unit's options
diagnose Run self-test
download Download config file
exit Quit this shell
ffbb Show the number of POST fault states
help Get more: “help all” or “help help”
install Download and program an image into flash
log Add a message to the diagnostic log
loglevel Report or change diagnostic log level
netstat Show IP information
nslookup Send DNS query for host
ping Send ICMP echo request
quit Quit this shell
6rd-check Send a 6rd loopback packet to the border gateway
reset Reset subsystems
restart Restart unit
show Show system information
start Start subsystem
status Show basic status of unit
telnet Telnet to a remote host
traceroute Send traceroute probes
upload Upload config file
view Show configuration information
who Show who is using the shell
wps Enter Wireless Protection Settings mode
To Next Page
