Arris NVG599 - Show Crash

Administrator’s Handbook
110
restart [ seconds ]
Restarts your NVG599 device. If you include the optional seconds argument, your NVG599 will restart when
the specified number of seconds have elapsed. You must enter the complete restart command to initiate a
restart.
show all-info
Displays all settings currently configured in the NVG599 device.
show bridge interfaces
Displays bridge interfaces maintained by the NVG599 device.
show bridge table
Displays the bridging table maintained by the NVG599 device.
show config
Dumps the ARRIS Gateway’s configuration script just as the script command does in Configure mode.
show crash
Displays the most recent crash information, if any, for your NVG599 device.
show dhcp server leases
Displays the DHCP leases stored in RAM by your NVG599 device.
show dhcp client
Displays the DHCP clients stored in RAM by your NVG599 device.
show dsl [ all ]
Displays DSL port statistics, such as upstream and downstream connection rates and noise levels.
show dslf device-association
Displays LAN devices that conform with the TR111 Gateway requirement. It displays IP address, manufacture
OUI, and serial number.
show enet [ all ]
Displays Ethernet interface statistics maintained by the NVG599 device. Supports display of individual LAN
switch port statistics as well as WAN Ethernet statistics (where applicable).
Example:
Ethernet driver full statistics - LAN
10/100/1000 Ethernet
Port Status: Link up