Arris NVG599 - Pppoe Relay Commands; NAT Pinhole Commands

157
PPPoE Relay Commands
set pppoe-relay enable [ on | off ]
Allows the NVG599 device to forward PPPoE packets. Default is on.
set pppoe-relay max-sessions [ 0... 4 ]
Specifies the maximum number of PPPoE relay sessions. Default is 4.
NAT Pinhole Commands
NAT pinholes let you pass specific types of network traffic through the NAT interfaces on the NVG599. NAT
pinholes allow you to route selected types of network traffic, such as FTP requests or HTTP (Web) connections,
to a specific host behind the NVG599 transparently.
To set up NAT pinholes, you identify the type(s) of traffic you want to redirect by port number, and you specify
the internal host to which each specified type of traffic should be directed.
The following list identifies protocol type and port number for common TCP/IP protocols:
 FTP (TCP 21)
 Telnet (TCP 23)
 SMTP (TCP 25),
 TFTP (UDP 69)
set pinhole name name protocol [ tcp | udp ]
Specifies the identifier for the entry in the NVG599 device's pinhole table. You can name pinhole table entries
sequentially (1, 2, 3), by port number (21, 80, 23), by protocol, or by some other naming scheme. Specifies the
type of protocol being redirected.
set pinhole name name ext-port-range [ 0 - 49151 ]
Specifies the first and last port number in the range being translated.
set pinhole name name int-addr ipaddr
Specifies the IP address of the internal host to which traffic of the specified type should be transferred.
set pinhole name name int-start-port [ 0 - 65535 ]
Specifies the port number your NVG599 device should use when forwarding traffic of the specified type. Under
most circumstances, you would use the same number for the external and internal port.

NOTE:
When configuring a PPPoE connection, you must also configure the required PPPoE authentication details
(such as user name and password combinations) on the client computer.